4 PACK OF HONDA BLINKERS (BLINKERSET4) temp out of stock

THESE ARE COPYS OF THE ORIDGINAL HONDA BLINKERS, METAL CHROMED AND AMBER LENS FROM THE 68 TO 79 ERA. 6 VOLT SINGLE ELEMENT BULBS. QUANITY OF THIS ITEM IS 1 SET OF FOUR BLINKER ASSYS.

ON THE SUBJECT OF ADDING BLINKERS TO A CT THAT DIDN'T HAVE FACTORY BLINKERS......

sorry if your not a bike electrician i wouldn't try adding these by yourself. it does get involved. we do sell all the parts you need,

http://www.dratv.com/4pacofhonbli.html

but it got me into trouble when i used to try to help people figure out how to install the kits.

so NOW (: i only sell the parts for this task...

THANK YOU !!!

BEATRICE CYCLE INC.

UNIVERSAL BLINKER INSTALL KIT 12v_OR_6v temp out of stock

THIS KIT REQUIRES 4 HONDA EARLY 70'S TYPE BLINKERS.

IF YOU DON'T HAVE THEM WE HAVE NEW ONES LISTED BELOW ON THIS PAGE

1_1/4" BLINKER STAYS UNIVERSAL (SOLD_EA) 2/12M (75F/SHORT)

THIS HAS 10MM BOLT TYPE THREADS, SOME BIKES USED THIS AS THE HEADLIGHT BUCKET PIVOT/BLINKER STAY . IT IS HOLLOW FOR THE WIRE TO GO THRU. WORKS FOR HONDA COMMON 68 THRU 79 CHROME BLINKERS.

SOME COMMONLY USED TERMINALS _ CLICK ON PICTURE TO GET TERMINAL'S "TM" NUMBER

6 VOLT TURN SIGNAL RELAY UNIT WITH UNIVERSAL RUBBER MOUNT (77L)

THIS WILL REPLACE A BURNED OUT RELAY OR WORK IN A SYSTEM THAT NEVER HAD TURN SIGNALS AND A TURN SIGNAL RELAY BEFORE

CHEAP_COPY OF_EARLY_HONDA BLINKER (: (SOLD_EACH) (1003P)

OK HERE IS THE SCOOP,, THESE LOOK AMAZINGLY CLOSE TO THE ORIGINAL HONDA BLINKERS, BUT ARE A CHROME PLATED PLASTIC HOUSING WITH A SMALLER 6V BULB.

SEE THE LOWER PICTURE WHERE I HAVE JUST FYI INSTALLED ONE ON A HONDA BLINKER STEM, FITS GOOD !

THE BLINKERS DON'T HAVE SPLINES WHERE THEY GO ONTO THE STEM, BUT BEING PLASTIC,, WHEN YOU TIGHTEN DOWN THE INCLUDED BOLT AND NUT THEY DIG IN AND DON'T SPIN.. JUST DON'T OVER TIGHTEN THE BOLT, REMEMBER THEY ARE PLASTIC.