YOU MAY NEED A GASKET IF YOUR OLD ONE IS BAD. THIS PULLSTART TAKES 3EA 6MM X 16MM PAN HEAD PHILLIP SCREWS TO CONNECT IT TO THE CASE(SEE BELOW) *(1) ATC70 RECOIL_STARTER COMPLETE_ASSY (oem_Honda) 1981_to_1985 (73_to_80_READ) (99F) XED 099F 6MM X 16MM PAN HEAD SCREW 337802$0.38 *BOLT 6MM X 16MM (65T) 65T$0.54 ORIDGINAL STYLE 6MM FLAT WASHER ALL_SILVER SMOOTH FINISH MADE_IN_JAPAN (331036) PENNY NOT INCLUDED * THESE ARE MADE IN JAPAN !!! THIS WASHER HAS A CHROME-ISH LOOK TO IT JUST LIKE THE OLD HONDA WASHERS HAD. 331036 6MM FLAT$0.19 (15) PULLY BOLTS TO FLYWHEEL FOR STARTER ATC70'S (99B) XEDHONDA CALLS THIS A PULLY, BUT I CALL IT THE DOG CATCHER BECAUSE IT CATCHES THE RATCHET DOGS TO SPIN THE MOTOR OVER _______________________________________________ THE HOLES FOR THE DOGS TO INTER STARTS AT 5/16" FROM THE BOTTOM. OR 1/4" FROM THE BOTTOM OF THE CUP TO THE START OF THE HOLE AND THE HOLES ARE 3/8" TALL AND 13/16" LONG 099B *GASKET PULL START ATC70 (99E) THIS IS A GOOD INSURANCE PART, AS YOU DON'T WANT DIRT AND WATER GETTING TO THE INSIDE OF THE PULL STARTER, OR EVEN MORE IMPORTANTLY THE POINTS!!! 99E$2.99